HP Spooler FASTP Manual page 327

EMS Messages
512
proc-num DEV: device-name SPI SSPUTTKN token-name Error:
%nnnnnn
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
token-name
is the name of the token.
%nnnnnn
is the octal return code from the SSPUTTKN procedure.
This message can be generated by FASTPXNS or FASTPX25 only.
For FASTPXNS, the cause, effect, and recovery are as follows:
Cause. FASTPXNS could not insert the specified token into the SPI buffer using the
SPI SSPUTTKN procedure. This error indicates FASTPXNS is having difficulty
obtaining the Ethernet address of the TLAM controller. This address is obtained using
the SPI interface to TLAM through the SCP process (usually $ZNET).
Effect. The device is placed offline.
Recovery. To correct the problem:

Ensure that the SCP process is running correctly.

Check that the following command works correctly:
SCF INFO SERVICE $lan.#L18023
where
lan
is the name of the TLAM IOP.

If your installation doesn't use $ZNET, check that you have added a DEFINE=SCP
statement before running the Spooler Supervisor.
If the error persists, contact your service provider as described in
Reporting Problems
For FASTPX25, the cause, effect, and recovery are as follows:
Spooler FASTP Network Print Processes Manual — 427528-006
on page 8-1.
B - 115
FASTP EMS 512 Text Messages
Troubleshooting and