Configure Mpls Vlan Ldp Propagate - Extreme Networks ExtremeWare Command Reference Manual

MPLS Commands—BlackDiamond Switch Only

configure mpls vlan ldp propagate

configure mpls vlan [<vlan name> | all] ldp propagate [all | none |
route-map <route_map>]
Description
Configures a filter to be used by LDP when propagating unsolicited label mappings to all LDP
neighbors on one or all VLANs.
Syntax Description
vlan name Specifies a VLAN name.
all Specifies all VLANs.
all Specifies that all unsolicited label mappings are propagated to the VLAN.
none Specifies that no unsolicited label mappings are propagated to the VLAN.
route_map Specifies the route map used to permit or deny the propagation of unsolicited label mappings to
the VLAN.
Default
All unsolicited label mappings are propagated to the VLAN.
Usage Guidelines
This command configures a filter to be used by LDP when propagating unsolicited label mappings to
all LDP neighbors on the specified VLAN. If all VLANs are selected, the settings of this command apply
to all MPLS-enabled VLANs.
Example
The following command configures a filter to be used by LDP when propagating unsolicited label
mappings to vlan1:
configure mpls vlan vlan1 ldp propagate route-map bgp_out
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.8b12.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the BlackDiamond switch only.
2554 ExtremeWare 7.7 Command Reference Guide