Acquiring Copy Pair Information From One Site Of A Copy Pair; Copy Pair Status Transitions - HP XP P9500 Software User's Manual

Table 19 P-VOL/S-VOL statuses and copy pair statuses for each copy pair (for BC Z)
S-VOL
SMP
SMP SMP
PND
DUP
SU-P
SOP
SER
SVS
REV
SI-P
INV SMP

Acquiring Copy Pair information from one site of a Copy Pair

If you attempt to acquire copy pair information from an inaccessible site (due to a line failure, for
example), an error will occur even though information from available sites has been acquired. In
such a case, you can prevent the error by using the TO parameter, which allows you to specify
the site of the copy pair (P-VOL or S-VOL when they were defined) that can acquire information
and then executing the YKQUERY command.
For more information about executing the YKQUERY command with the TO parameter specified,
see the explanations for the REXX variables, updated by the YKQUERY command with the TO
parameter specified, in the HP P9000 for Business Continuity Manager Software Reference Guide.

Copy Pair Status Transitions

Figure 38 (page 72)
commands.
PND DUP SU-P
PND DUP TRN
PND DUP TRN
PND DUP TRN
PND DUP TRN
PND DUP TRN
PND DUP TRN
PND DUP TRN
PND DUP TRN
PND DUP TRN
PND DUP TRN
and Figure 39 (page 73)
P-VOL
SOP SER SVS
SOP SER SVS
SOP SER SVS
SOP SER SVS
SOP SER SVS
SOP SER SVS
SOP SER SVS
SOP SER SVS
SOP SER SVS
SOP SER SVS
SOP SER SVS
show the transitions for copy pair statuses by CLI
Understanding Copy Group Operations
REV SI-P INV
REV TRN SMP
REV TRN PND
REV TRN DUP
REV TRN TRN
REV TRN SOP
REV TRN SER
REV TRN SVS
REV TRN REV
REV TRN TRN
REV TRN INV
71