Operands; Example; Stopping Business Continuity Manager Monitor; Format - HP XP P9500 Software User's Manual

Operands

cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup of the Business Continuity Manager
Monitor instance you are going to start. The standard name is YKBCMMON.
identification-name
Used to specify the identification name of the cataloged procedure for startup. This operand
uniquely identifies each job when the same name is used for the cataloged procedure for startup
to perform multiple jobs.

Example

To start a Business Continuity Manager Monitor instance with the following conditions, enter the
command shown below:
Name of the cataloged procedure: YKBCMMON
Identification name: YK
START YKBCMMON.YK

Stopping Business Continuity Manager Monitor

To stop Business Continuity Manager Monitor, use the MODIFY STOP command. You can also
use the STOP command in the operating system.

Format

If both the name of the cataloged procedure for startup and the identification name are specified
in the START command, use either of the following formats.
MODIFY
1 [cataloged-procedure-for-startup-name.]identification-name
,STOP[ 1(IMMEDIATE|label-name)]
STOP
1 [cataloged-procedure-for-startup-name.]identification-name
If only the name of the cataloged procedure for startup is specified in the START command, use
either of the following formats.
MODIFY
1 [cataloged-procedure-for-startup-name
,STOP[ 1(IMMEDIATE|label-name)]
STOP
1 [cataloged-procedure-for-startup-name
Operands
cataloged-procedure-for-startup-name
Used to specify the name of the cataloged procedure for startup that was specified in the START
command when Business Continuity Manager Monitor was started.
identification-name
Used to specify the identification name that was specified in the START command when Business
Continuity Manager Monitor was started.
STOP
518 Automatic operation using BCM Monitor