Specifying A Route List Id - HP XP P9500 Software User's Manual

Figure 64 Example of a Remote Scan configuration
For details on how to use the ISPF panel, see

Specifying a Route List ID

Specify a route list ID in the Set Defaults panel.
Preset RouteListID: Provide the route list ID for the route from the Primary site to the Secondary
site.
NOTE:
panel (that otherwise would be displayed after route list creation) by specifying a pre-selected
route list name of up to eight characters in this field.
Remote DKC Function: Indicate the use of the Remote DKC Control Function (type Y).
For the procedures for performing this operation, see
If no route list has been defined, you can suppress the display of the LOAD Option
"Remote scan procedure" (page
"Specifying a route list ID" (page
Acquiring volume information (preparations) 109
472).
472).