Adding The Copy Pair To The Copy Group (Bc); Defining The Copy Group Id And Copy Group Attributes (Ca) - HP XP P9500 Software User's Manual

8. Press Enter.
The Copy Group Pair Detail panel appears.

Adding the copy pair to the copy group (BC)

The operations for adding a copy pair to an BC copy group are the same as those in section
"Adding the copy pair to the copy group (Cnt Ac-J Z)" (page

Defining the copy group ID and copy group attributes (CA)

To define a CA copy group:
1. Display the Discover/Define Configuration panel and choose 4 Copy Group Definitions.
The Copy Group Selection List panel displays.
2. Press the F5=Add key to add a CA copy group.
The Add Copy Group panel displays.
3. Specify the Copy Group ID, Device Address Domain (for both Primary and Secondary), and
Copy Group Type (CA).
4. Press the Enter key.
The Setting C/T ID Attributes panel displays.
5. Press Enter key to close the Setting C/T ID Attributes panel (for Cnt Ac-S Z, C/T ID (JNLG) is
optional).
The Copy Group Pair Detail panel appears (in the initial state, no list of copy pairs appears
because no copy pair is defined at this point).
6. Press the F4=Attr key.
The Copy Group Attributes (CA) panel appears.
480).
Defining a copy group 483