Definition Procedure (3Dc Multi-Target Configuration) - HP XP P9500 Software User's Manual

Table 40 How to Prepare the Configuration Files at Each Site (continued)
File Type
Path set definition file
Route list definition
file/Command
device definition file
Copy group
definition file
NOTE: If you define the route list, the route list definition file and the command device definition
file will be created at the same time.

Definition Procedure (3DC Multi-Target Configuration)

First, set the items that need to be set by using Remote Web Console from among the items listed
in Table 38 (page
This section explains the definition of a 3DC Multi-Target configuration as shown in the ISPF panel.
The following explains the legend for the figures used for the operation procedures described in
this section:
152 Configuration Definitions
Contents
On the Primary Site
Define a path set
An inter-control unit
logical path from
the primary site to
the local site
An inter-disk
controller logical
path from the
primary site to the
remote site
An inter-control unit Not required
logical path from the
local site to the
primary site
An inter-disk controller Not required
logical path from the
remote site to the
primary site
Define a route list
A route/command
device from the
primary site to the
local site
A route/command
device from the
primary site to the
remote site
A route/command Not required
device of Local ->
Primary -> Remote
A route/command Not required
device of Remote ->
Local -> Primary
A Cnt-Ac S copy for Define a copy group
Mainframe group
A Cnt-Ac J copy for Define a copy group
Mainframe group
150).
How to Prepare
On the Local Site On the Secondary Site
Not required Not required
Define a path set Not required
Not required Define a path set
Not required Not required
Define a route list Not required
Not required Define a route list
Transfer from the Transfer from the
primary site primary site