What To Do When An Error Occurs While Creating A Configuration File; How To Correct An Error That Occurs While Creating Or Updating A Configuration File - HP XP P9500 Software User's Manual

Table 106 Recovering from Other Copy Pair Failures (continued)
VOLB
SWAPP-
nl
ING
Legend:
VOLA: A volume on the storage system of the primary site
VOLB: A volume on the storage system of the secondary site
(P): Command executed from the primary site
(S): Command executed from the secondary site
N/A: Not applicable

What To Do When an Error Occurs While Creating a Configuration File

This section describes what actions to take when an error occurs while creating or updating a
configuration file.

How To Correct an Error that Occurs While Creating or Updating a Configuration File

If an error occurs when you are creating or updating a configuration file in the ISPF panel, an error
message appears in the Exception Message panel. If you press the Enter key or F12=CANCEL key
in this panel, one of the following occurs:
The panel for creating or updating a configuration file reappears.
The Confirm Retry of Configuration File Create panel appears.
–
SIMPLEX DUPLEX
specified (P)
YKMAKE (P)
YKRECVER YKSUSPND
with DEVN with DEVN
specified specified (P)
(S)
YKRESYNC
with DEVN
YKMAKE
with DEVN specified (P)
specified (P)
VOLA
P-VOL
SUSPCU/ DUPLEX
nl
SUSPER
N/A
YKRESYNC
with DEVN
specified (P)
S-VOL
SUSPCU/ SWAPPING
nl
SUSPER
YKQUERY (P)
YKQUERY
(S)
YKRECVER
with DEVN
YKRECVER
with DEVN
specified (P)
specified
YKQUERY (S)
(S)
YKRECVER
YKQUERY
with DEVN
(P)
specified (S)
YKDELETE
YKMAKE with
with DEVN
DEVN
specified
specified (P)
(P)
YKMAKE
with DEVN
specified
(P)
Recovering from a Failure 575