Scan Copy Pair Inside Storage System Panel - HP XP P9500 Reference Manual

Scan Copy Pair Inside Storage System Panel

When SCANPAIR is entered on the command line and the Enter key is pressed on the Copy Group
Selection List panel, the display switches to the Scan Copy Pair Inside Storage System panel for
scanning the P-VOL of the PPRC copy pair and generating a copy group definition file. Execute
the YKH2B command to create a copy group definition file for a CA copy group with the HyperSwap
attribute from a PPRC copy pair for which HyperSwaps are enabled. For details about the YKH2B
command, see
Figure 77 (page 90)
Figure 77 Scan Copy Pair Inside Storage System Panel
Table 56 (page 90)
Table 56 Contents of the Scan Copy Pair Inside Storage System Panel
Item
Device Address
Domain
CA Copy Group ID
TCA Copy Group ID
90 ISPF Panels
"YKH2B Command" (page
shows the Scan Copy Pair Inside Storage System panel.
describes the items in the Scan Copy Pair Inside Storage System panel.
Primary
Secondary
BC Pair (S-VOL) Non
Gen'ed
213).
Description
Specify the Device Address Domain ID to which the P-VOL of the PPRC
copy pairs to be scanned belong (required).
Use no more than 28 alphanumeric characters. If the specification
exceeds 8 characters, place a period every 8 characters. Hyphens
cannot be specified.
Specify the Device Address Domain ID of the S-VOL of the PPRC copy
pairs to be scanned belong (required for CA or CAA).
Use no more than 28 alphanumeric characters. If the specification
exceeds 8 characters, place a period every 8 characters. Hyphens
cannot be specified.
Specify the Non Gen'ed Device Address Domain ID to which the S-VOL
of the PPRC BC copy pairs to be scanned belong (required when the
S-VOL of the BC copy pair is a Non Gen'ed volume).
Use no more than 28 alphanumeric characters. If the specification
exceeds 8 characters, place a period every 8 characters. Hyphens
cannot be specified.
Specify a CA copy group name (required only when a Device Address
Domain ID is specified for Secondary).
Two-digit serial numbers beginning with 00 are assigned in ascending
order to the copy group names specified by this parameter (for
example, 00, 01, 02...). You can specify a maximum of six characters
for a copy group name. Do not use hyphens. The initial display is
MYTCS.
Specify a TCA copy group name (required only when a Device Address
Domain ID is specified for Secondary).