HP XP P9500 Software User's Manual page 67

Table 14 Copy pair statuses of volumes obtained by the YKQRYDEV command (Cnt Ac-S Z or Cnt
Ac-A) (continued)
Copy pair status acquired by
YKQRYDEV
SUSPER (09)
SUSPER (50)
TRANS (60)
TRANS (61)
SUSPER (62)
SUSPER (A0)
Table 15 Copy pair statuses of volumes obtained by the YKQRYDEV command (Cnt Ac-J Z)
Copy pair status acquired by
YKQRYDEV
SIMPLEX
PENDING (01)
DUPLEX (02)
SUSPOP (03)
SUSPOP (04)
SWAPPING (04)
SUSPOP (05)
SUSPCU (06)
SUSPER (07)
SUSPCU (08)
Status of the copy pair in the
storage system
Suspended
Suspended
Suspending
Deleting
Suspended
SEQCHK
Status of the copy pair in the
storage system
Simplex
Duplex Pending
Duplex
Suspended
Suspended
Suspended
Suspended
Suspended
Suspended
Suspended
Description
with the secondary storage system or an I/O error during
update copying.
The copy pair has been suspended because the primary
storage system detected that the pair control information
stored in memory was volatile when the power was turned
on (IMPL). This error occurs when the primary storage
system is turned off after the backup time for non-volatile
memory has been exceeded.
The copy pair has been suspended because the data
between the P-VOL data and the S-VOL data did not match
during the initial copying phase. Invalid track formatting
causes this error.
The copy pair is changing to the suspend status.
The copy pair is changing to the simplex status.
The primary storage system has suspended all the copy
pairs due to a planned outage (turned off).
An update I/O without a timestamp was detected on a
pair in a consistency group for which SYSTEM is set as the
timer type.
Description
SIMPLEX status
The copy pair is changing to the duplex status (during an
initial copy or resynchronization).
Duplex status.
The user has suspended the copy pair from the P-VOL.
The user has suspended the S-VOL. (The P-VOL has been
updated and the differential data between the P-VOL and
S-VOL is being recorded.)
The user has suspended a copy pair for which REVERSE
is specified.
The copy pair has been suspended because the secondary
storage system has received a suspend request from the
primary storage system.
The copy pair has been suspended because the primary
storage system has detected an error status on the
secondary storage system.
The P-VOL has been suspended because the user dissolved
the copy pair from the S-VOL (changed to the SIMPLEX
status).
The copy pair has been suspended because the primary
storage system detected either an error during migration
with the secondary storage system or an I/O error during
update copying.
Understanding Copy Group Operations 67