This section describes the image of command device and route list definitions, and the procedure
for defining a copy group.
Figure 72 (page 124)
use the Continuous Access Synchronous Consistency Preservation Function from the primary site.
Figure 72 Example of ommand device and route list definitions for Cnt Ac-S Z with a consistency
group ID
Route list TCS2DC requires only the routes of primary storage systems.
Only primary storage systems 351 14 and 351 16 require command device definitions. Remote
storage systems do not need command device definitions.
Defining a copy group
To use the Continuous Access Synchronous consistency preservation function, define a copy group
by performing the following steps:
1.
In the Add Copy Group panel, specify Cnt Ac-S for Copy Group Type.
2.
In the Setting C/T ID Attributes panel, specify a consistency group ID.
3.
In the Copy Group Attributes panel, specify Y for FREEZE SCP.
To see the procedure for defining a copy group from the ISPF panels, see
(page
477).
Environment definition for using the Reverse Resync function
This section describes environment definitions for using the Reverse Resync function.
124 Preparing to use Business Continuity Manager
shows an example of command device and route list definitions when you
"Defining a copy group"