Preparing The Configuration Files (Hyperswap) - HP XP P9500 Software User's Manual

Table 49 Required Configuration Files (HyperSwap) (continued)
Route list definition file and command
device definition file
Path set definition files

Preparing the configuration files (HyperSwap)

Table 50 (page 179)
Table 50 How to Prepare the Configuration Files at Each Site (HyperSwap)
File Type
Disk configuration
definition file
Item
The following route lists are required:
A route for normal operations
From the local storage system to
the remote storage system
A route for local storage system
failures
From the primary storage system to
the remote storage system
Routes for primary host failures
From the remote storage system to
the primary storage system
From the remote storage system to
the local storage system
The following path sets are required
for logical paths.
An inter-control unit logical path
(bidirectional) must be established
between the primary and local
storage system.
An inter-disk controller logical path
(bidirectional) must be established
between the primary and remote
storage system.
An inter-disk controller logical path
(bidirectional) must be established
between the local and remote
storage system.
shows how to prepare the configuration files at each site.
Contents
The primary site
configuration
The secondary site
configuration
Description
On the Primary Site
Perform a local scan
Transfer from the secondary
site
Defining a 2DC configuration with HyperSwap and Cnt-Ac J Z 179
Remarks
Set this item before starting a copy
operation.
The name of the route list for monitoring
HyperSwap must be different from the
name of the route list for working
around local storage system troubles.
Do not use these route lists at the same
time.
This item is not necessary if you use
Remote Web Console to set up logical
paths.
How to Prepare
On the Secondary Site
Transfer from the primary
site
Perform a local scan