5. (Optional) Type a new name for the zone configuration.
6. Click OK or Apply to save your changes.
Finding a member in one or more zones
Use this procedure to locate all instances of a member in the Zones list on the Zone DB tab.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. If you want to show all fabrics discovered in the Potential Members list, right-click in the
5. Select the device or port you want to find in the Potential Members list.
6. Click Find > between the Potential Members list and Zones list.
Finding a zone member in the potential member list
Use this procedure to locate a zone member in the Potential Members list on the Zone DB tab.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
4. Select the zone member in the Zones list that you want to find in the Potential Members list.
DCFM Professional User Manual
53-1001773-01
If you key in a new name, press Enter to save the name.
Depending on the characters included in the name you enter, a message may display
informing you the name contains characters that are not accepted by some switch vendors,
and asking whether you want to proceed. Click Yes to continue, or No to cancel the renaming.
(For zone configuration name requirements and limitations, refer to
conventions"
on page 442.)
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making
changes to the same areas.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
Potential Members list and select Display All.
Press SHIFT or CTRL and click each zone to select more than one zone.
•
If the member is found, all instances of the zone member found are highlighted in the
Zones list.
•
If the member is not found, a message displays informing you of this. Click OK to close the
message box.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
Zoning administration
"Zoning naming
15
473