Secondary Site Without A Host - HP XP P9500 Software User's Manual

Hp p9000 business continuity manager user guide

Hide thumbs Also See for XP P9500:

Table of Contents

Figure 75 Process flow for defining a 2DC configuration with a host at the secondary site

#1 This procedure is not required if the path has been established using Remote Web Console.

#2 A logical path must be built for the reverse direction if you are:

Using Continuous Access Journal for Mainframe

Using the Reverse Resync Function

Operating the primary site storage systems from the secondary site by using the Remote DKC

Control Function.

#3 This procedure is not required if you do not operate the primary site storage systems from the

secondary site by using the Remote DKC Control Function. However, if the Continuous Access

Synchronous Consistency Preservation Function is used at the secondary site, a command device

is required at the secondary site.

To operate the primary site storage systems at the secondary site, you need to transfer

the configuration files created at the primary site to the secondary site.

Secondary site without a host

When a host is not installed at the secondary site, you can perform a remote scan from the primary

site to acquire volume information of the secondary site. You do not need to transfer the configuration

files from the primary site to the secondary site.

130 Configuration Definitions