Canceling The Luks Settings - Hitachi XP P9500 User Manual

3. Creating an HDLM Environment
DEVICE /dev/sddlmaa1
After the correction:
DEVICE /dev/sdh1 /dev/sdo1
Specify all SCSI devices that correspond to HDLM devices.
When you edit the
partition numbers.
11. Execute the following command to deactivate the md device:
# mdadm -Ss /dev/md0
12. Make sure that the md device has been deactivated.
In the following example, the
# cat /proc/mdstat
Personalities : [linear]
unused devices: <none>
Make sure that
#
Although
operational problems.
13. Activate the md device.
Perform steps 11 to 14 in (1) Migrating to md Devices for which the MULTIPATH
Function Is Not Used.
Note that, in step 13 in (1) Migrating to md Devices for which the MULTIPATH
Function Is Not Used,
However, there are no operational problems.

3.23.10 Canceling the LUKS Settings

This subsection describes how to migrate LUKS from a HDLM device environment
using LUKS to SCSI devices.
To migrate from
1. Change the multi-path configuration to a single-path configuration.
2. Check the SCSI device to be migrated from the HDLM device.
Execute the HDLM-configuration definition utility (
310
line, change only the device names. Do not change the
DEVICE
MULTIPATH
#
is not displayed.
md0 : active
will be displayed until the host is restarted, there are no
[linear]
will be displayed until the host is restarted.
[linear]
to
/dev/sddlmaa /dev/sdh
function is used for the md device:
[multipath]
:
dlmcfgmgr)
with the
-v