Viewing And Setting Up The Operating Environment - Hitachi XP P9500 User Manual

4. HDLM Operation
Operation name = clear [y/n]:y
KAPL01001-I The HDLM command completed normally. Operation
name = clear, completion time = yyyy/mm/dd hh:mm:ss
#
3. Check to see whether the statistical information for all the paths has been
initialized.
The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -path

4.3.7 Viewing and Setting Up the Operating Environment

This section explains how to display and set up the HDLM operating environment.
(1) Viewing the Operating Environment
To display the operating environment, execute the
operation with the
The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Reservation Status
Intermittent Error Monitor
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
To display the operating environment of the audit log, execute the HDLM command's
operation with the
view
The following example shows how to execute the command:
346
and parameters specified.
-sys -sfunc
and
-sys -audlog
command's
dlnkmgr
x.x.x-xx
:
:
: on(extended lio)
:
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
:
: off
parameters specified.
view