Hitachi XP P9500 User Manual page 172

3. Creating an HDLM Environment
# rpm -qi HDLM
Name
Version
Release
:
If
HDLM Version
x.x.x.x.xxx indicates the HDLM version that was installed.
8. If IP-SAN is used for the connection between the host and the storage system,
change
iscsi_boot=n
hdlm.conf
9. If you want to set the HDLM driver options, run the
For details on this utility, see 7.6 dlmsetopt Utility for Setting HDLM Driver
Options.
If you performed this step, go to step 12.
10. When you want to install HDLM without restarting the host, go to step 11. When
you want to install HDLM with restarting the host, then go to step 12.
11. Execute the
For details, see 7.7 dlmstart Utility for Starting HDLM.
12. Add
/opt/DynamicLinkManager/bin
the environment setup file for the shell used by the root user.
Add the following code to the
settings file for the root user. This makes executing the HDLM commands and
HDLM utilities easier.
When the BourneAgain shell or Korn shell is used:
PATH=$PATH:/opt/DynamicLinkManager/bin ; export PATH
When the C shell is used:
set path= ( $path /opt/DynamicLinkManager/bin )
If the
PATH
commands and utilities.
If you have performed steps 11, go to step 14.
13. Restart the host.
Execute the following command to restart the host:
# shutdown -r now
148
: HDLM
x.x.x.x.xxx
:
xx
:
is x.x.x.x.xxx, the installed version of HDLM is correct.
, written in the
file, to
iscsi_boot=y
utility for starting HDLM.
dlmstart
PATH
environment variable is not set, specify an absolute path to execute
/etc/opt/DynamicLinkManager/
.
dlmsetopt
in the environment variable
environment variable in the environment
utility.
in
PATH