Hitachi XP P9500 User Manual page 299

monitoring, specify
parameters to specify intermittent error conditions (the conditions used by the system
to determine whether an intermittent error is occurring). In the
specify the monitoring interval for an intermittent error. In the
specify the number of times that the error is to occur. When these parameters are
omitted and 3 or more errors occur within 30 minutes, the system assumes that an
intermittent error is occurring.
(5) Setting the Error Log Collection Level
The error log (the HDLM manager log (
to )) collection level can be set.
1 16
Table 3-58: Values for the Error Log Collection Level Setting lists and describes the
values for the error log collection level setting.
Table 3-58: Values for the Error Log Collection Level Setting
Value
0
1
2
3
4
If an error occurs, you might have to change the collection level to 1 or higher to collect
any log information.
The higher this value is set, the more information that will be output. As the amount of
log information to be output increases, it will take less time to overwrite the old error
log information with the new information.
The following is an example of using a command to set the error log collection level.
# /opt/DynamicLinkManager/bin/dlnkmgr set -ellv 2
Specify the error log collection level as a number.
(6) Setting the Trace Level
You can set up the trace level for a trace file
. When you specify
off
dlmmgr
No error logs are collected.
All information for errors of the "Error" level or higher is
collected.
All information for errors of the "Warning" level or higher is
collected.
All information for errors of the "Information" level or
higher is collected.
All information for errors of the "Information" level or
higher (including maintenance information) is collected.
3. Creating an HDLM Environment
, you can use the
on -intvl
-intvl
-iemnum
n (n indicates a file number from
.log
Description
n (n indicates a file number
hdlmtr .log
and
-iemnum
parameter,
parameter,
275