Hitachi XP P9500 User Manual page 383

Firmware : 260803
WWPN:2400000047010270
WWPN:2400000047010272
The number that follows a
HBA.
The following steps assume that the HBAs whose WWN information is
underlined above are to be replaced.
2. Execute the
view
) to check the information about the paths that pass through the
-hbaportwwn
HBAs you want to replace.
See the port WWN information of the HBAs you checked in step 1 and
displayed as the execution result to check the host port number and
HBAPortWWN
the bus number displayed in
In , the leftmost number is the host port number. The number between
PathName
the period to the right of the host port number and the next period is the bus
number.
Specify the host port number and the bus number when you place the path in the
status in step 3.
Offline(C)
In this execution example, the host port number and the bus number
corresponding to the port WWN information of the HBAs to be replaced (the
underlined section) are shaded.
Device:hfcldd2
Device:hfcldd3
keyword is the port WWN information of an
WWPN
operation of the
dlnkmgr
.
PathName
4. HDLM Operation
[LinkUp]
[LinkUp]
command (
dlnkmgr view -path
359