Starting And Stopping The Hdlm Manager; Starting The Hdlm Manager - Hitachi XP P9500 User Manual

4. HDLM Operation

4.4 Starting and Stopping the HDLM Manager

If an error occurs in the system, such as in an HDLM program, you may need to
manually stop or start HDLM to recover from the error.

4.4.1 Starting the HDLM Manager

To start the HDLM manager, log in to Linux as a user with root permissions and then
execute the following command.
# /etc/init.d/DLMManager start
Starting DLMManager:
Lower case characters can be used for the command name (
# /etc/init.d/dlmmanager start
Starting DLMManager:
The startup script that was set up during HDLM installation runs, and starts the HDLM
manager.
Note
• When you start the HDLM manager immediately after stopping it, confirm
that the HDLM manager has stopped (
opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
then start it.
• Even if the HDLM manager is running,
execute
If this happens, see 5.4.3 What To Do for the Program Error.
Important
When stopping the HDLM manager, even if a message indicating that the
HDLM manager has successfully stopped, it takes a few seconds more to
stop processes. Therefore, if you start the HDLM manager immediately after
stopping it, the HDLM manager is regarded as being started, and a message
indicating that the HDLM manager has successfully started is output.
However, starting of the HDLM manager is cancelled, and it will remain
inactivate.
Use one of the following procedures to confirm that the HDLM manager is active:
Use the
dlnkmgr
Execute the following command:
352
/opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
command's operation:
view
[ OK
dlmmanager
[ OK
is displayed when executing
Dead
might be displayed when you
Dead
]
).
]
/
), and
.