Hitachi XP P9500 User Manual page 209

Change the
default
configuration copied in step 11.
default=2
• When LILO or ELILO is used as the boot loader:
Specify
label
default linux-sd
15. If LILO is used as the boot loader, execute the
the new settings take effect.
16. Restart the host to make sure that booting from the SCSI device is possible.
17. Install HDLM.
To install HDLM, see 3.6.2 Performing a New Installation of HDLM perform
steps 2 to 12 to create an HDLM device. You will also need to perform step 13 if
you are only restarting the host. Note that the procedure differs depending on
whether the host is restarted after installation.
18. Execute the HDLM-configuration definition utility (
parameter specified to check the correspondence between the SCSI device and the
HDLM device.
# dlmcfgmgr -v
HDevName Management Device
/dev/sddlmaa
KAPL10302-I /sbin/dlmcfgmgr completed normally.
The column indicates the HDLM device, and the
HDevName
indicates SCSI device.
19. Execute the
dlmmkinitrd
RAM disk image file for HDLM.
For the initial RAM disk image file specified in the parameter, assign a name that
is different from all currently used names.
For details on the
dlmmkinitrd
Supporting a Boot Disk.
20. Back up the
/etc/fstab
21. Edit the
/etc/fstab
Change the mount points for the following HDLM management-target devices
from the SCSI device to the HDLM device:
• When
ELILO
number so that a boot can be performed using the
for .
default
configured /dev/sda
utility for supporting a boot disk to create an initial
utility, see 7.4 dlmmkinitrd Utility for
file.
file.
is used as the boot loader:
3. Creating an HDLM Environment
command to have
/sbin/lilo
with the
dlmcfgmgr)
Host Channel Target Lun
0 0
Device
-v
0 0
column
185