Hitachi XP P9500 User Manual page 224

3. Creating an HDLM Environment
Figure 3-9: Example of Executing the mount Command
The shaded portion indicates the SCSI device for which
This example assumes that IA32 uses
that uses
instead of
displayed as
Remove the
for the mounted file system. Perform steps 6 to 8 to remove the
the
/etc/fstab
For Red Hat Enterprise Linux 6, because there is a function for setting fixed
names to disk devices, aside from LABEL, block device names starting with
are also sometimes set. If a block device name is set, replace LABEL with
UUID=
the block device name starting with
LABEL is used.
If a block device name starting with
go to step 6.
If you are using SUSE LINUX Enterprise Server 10 or SUSE LINUX Enterprise
Server 11, the device name (
the
LABEL
with the device name (
LABEL
perform the same procedure as when
If the device name (
step 5. If not, go to step 6.
5. If the block device name or the
the following commands to check the SCSI device.
• For Red Hat Enterprise Linux 6
Execute the
200
as the boot loader, the mount point is displayed as
ELILO
(in the line where
/boot
instead of
vfat ext3
setting in the
LABEL
file.
udev
setting, but also in the
udev
name) is specified in the
udev
udev
command. Specify the block device name for
udevadm
LABEL
as the boot loader. When you use IPF
GRUB
is coded), and the file system type is
/boot
.
file according to the information
/etc/fstab
, and follow the procedure for when
UUID=
is set, go to step 5. If one is not set,
UUID=
name) might have been specified not only for
directory. In this case, replace
/dev/disk
name) in the
/dev/disk
is used.
LABEL
/dev/disk
name was specified in steps 3 and 4, execute
is set.
/boot/efi
setting in
LABEL
directory, and then
directory, go to
.
-n