C. Functional Differences Between Versions of HDLM
using the
C.5 Functional Differences Between Version 5.9.1 or Later and
Versions Earlier Than 5.9.1
In versions earlier than 5.9.1, the timeout value of
Therefore, depending on the connected storage system, a timeout occurs when the
response for
In versions 5.9.1 or later, you can use the
timeout value according to the storage system in use.
In versions earlier than 5.9.1, the message below will not be output when you
install HDLM. In versions 5.9.1 or later, the following message will be output
when you install HDLM.
•
Preparing packages for installation...
•
HDLM-
The following shows an execution example in Red Hat Enterprise Linux AS4:
# /media/cdrom/installhdlm
KAPL09093-I HDLM
y
Preparing packages for installation...
KAPL09076-I The permanent license was installed.
x.xx.x.xxx-xx
HDLM-
KAPL09043-I The installation of HDLM-
successfully.
#
C.6 Functional Differences Between Version 5.9 or Later and
Versions Earlier Than 5.9
The function for operating HDLM from the HDLM GUI or HDLM Web GUI is no
longer supported.
C.7 Functional Differences Between Version 5.8 or Later and
Versions Earlier Than 5.8
Table C-1: JRE/JDK Version Required for HDLM GUI describes the version of the
JRE or JDK required to use the HDLM GUI on a host.
704
utility.
dlmcfgmgr
is delayed.
SCSI INQUIRY
x.xx.x.xxx.
xx
-
xx-xx
will be installed. Is this OK ? [y/n]:
SCSI INQUIRY
utility to customize the
dlmsetopt
x.xx.x.xxx-xx
completed
is fixed.