Hitachi XP P9500 User Manual page 252

3. Creating an HDLM Environment
etc/elilo.conf
initial RAM disk image file and
Modify any incorrect specification.
If startup from the HDLM device still fails after you correctly specify the initial
RAM disk image file and
be corrupted. Execute the boot disk support utility to re-create the initial RAM
disk image file.
4. Restart the host to start the OS from the HDLM device.
(2) When a Prompt for a Password for Starting Maintenance Appears, and the OS
Stops
The probable causes of this error are as follows:
Startup from a SCSI device was selected in the boot loader configuration, but
etc/fstab
To correct the above error:
1. Enter the root user password.
2. Execute
3. In the
/etc/fstab
device.
4. Restart the host to start the OS from the SCSI device.
5. To restart the OS from an HDLM device, set up the environment according to the
following procedure:
Follow the procedure in 3.7.3 Settings for Using an HDLM Device as a Boot Disk
or 3.7.4 Upgrade Installation in an Environment Where an HDLM Device Is
Used as a Boot Disk.
228
file, or
/boot/grub/menu.lst
ramdisk_size
file was defined to mount an HDLM device.
mount -o remount rw /
file, change the mount destination of
file to make sure that the
are specified correctly.
ramdisk_size
, the initial RAM disk image file might
to mount the root directory again.
/
to the SCSI
root