Hitachi XP P9500 User Manual page 219

title HDLM-Red Hat Enterprise Linux (2.6.18-194.el5)
• When LILO or ELILO is used as the boot loader:
Change the underlined text as follows:
Before:
label=sd-HDLM_194.EL
After:
label=HDLM-HDLM_194.EL
22. Specify the initial RAM disk image file created in step 18 for
in the boot loader configuration file.
Change the
initrd
If you are using a Xen kernel, change the
to the initial RAM disk image file you created in step 18. For details on Xen
kernels, see Table 3-47: Xen Hypervisor Operating Environments Supported by
HDLM.
Keep in mind that the specification method for
boot loader.
If any options have been specified to suit the user environment, take care not to
delete those options.
23. In the boot loader configuration file, edit the settings to be used during a boot.
• When GRUB is the boot loader
Change the
default
configuration copied in step 20.
default=3
• When LILO or ELILO is used as the boot loader:
Specify
label
default HDLM-HDLM_194.EL
24. If LILO is used as the boot loader, execute the
the new settings take effect.
25. Edit the
/etc/fstab
Change the mount points for the following HDLM management-target devices
from the SCSI device to the HDLM device:
• When
ELILO
Root directory (
specification in the configuration that you copied in step 20.
initrd
number so that a boot can be performed using the
for .
default
file.
is used as the boot loader:
), ,
/ /boot/efi /tmp
3. Creating an HDLM Environment
initrd
file name specified in
differs depending on the
initrd
command to have
/sbin/lilo
, , ,
/usr /var swap
contained
module
195