Hitachi XP P9500 User Manual page 406

4. HDLM Operation
Legend:
a: Host ID (Port number of the host)
b: Channel number (Bus number)
c: Target ID
d: Lun (LU number of the host)
n: host port number
driver-name:
An example entry is shown below.
When adding a device by using a QLogic HBA driver in Red Hat Enterprise
Linux AS4/ES4:
# echo "scsi-qlascan" > /proc/scsi/qla2200/1
# cat /proc/scsi/qla2200/1
# echo "scsi add-single-device 1 0 1 1" > /proc/scsi/scsi
4. Wait until the automatic failback function starts, or execute the
command (
The relevant path is placed online.
The following is an example of executing the HDLM command:
# /opt/DynamicLinkManager/bin/dlnkmgr online -pathid
AutoPATH_ID
5. Refer to
execute the
relevant HDLM device is restored.
The following is an example of executing the
# /sbin/dlmcfgmgr -v
(10) Restoring the Path in Disconnected Status
This subsection describes how to restore the path to an HDLM device that was in
disconnected status (the cable was pulled out or broken).
1. Execute the HDLM-configuration definition utility (
while the path to the relevant HDLM device was in disconnected status.
The following are examples of executing the command:
# /sbin/dlmcfgmgr -v
382
xxxx (driver name in use)
qla
dlnkmgr online -pathid
/var/opt/DynamicLinkManager/log/dlmcfgmgr1.log
utility (
dlmcfgmgr
AutoPATH_ID).
) to check if the path to the
dlmcfgmgr -v
dlmcfgmgr
dlmcfgmgr -v
dlnkmgr
or
utility:
) to check