Hitachi XP P9500 User Manual page 528

7. Utility Reference
Example
To check the reservation keys, and then clear a reservation key:
1. Execute the
, and
sde
# /opt/DynamicLinkManager/bin/dlmpr -k sda sdb sdc sdd sde
sdf
sda Reservation Key : [0xaaaaaaaaaaaaaaaa]
Regist Key : [0xaaaaaaaaaaaaaaaa], Key Count : 1
sdb Reservation Key : [0xbbbbbbbbbbbbbbbb]
Regist Key : [0xaaaaaaaaaaaaaaaa], Key Count : 2
Regist Key : [0xbbbbbbbbbbbbbbbb], Key Count : 2
sdc Reservation Key : [0xbbbbbbbbbbbbbbbb]
Regist Key : [0xbbbbbbbbbbbbbbbb], Key Count : 4
sdd Reservation Key : [0xaaaaaaaaaaaaaaaa]
Regist Key : [0xaaaaaaaaaaaaaaaa], Key Count : 4
sde Reservation Key : [0x0000000000000000]
sdf Reservation Key : [0x0000000000000000]
Regist Key : [0xaaaaaaaaaaaaaaaa], Key Count : 1
Regist Key : [0xbbbbbbbbbbbbbbbb], Key Count : 1
2. Execute the
# /opt/DynamicLinkManager/bin/dlmpr -c sdb sdc
3. The confirmation message appears. Enter
KAPL10641-I Reservation Key will now be cleared. Is this OK?
[y/n]:y
KAPL10642-I Reservation Key of sdb was cleared.
KAPL10642-I Reservation Key of sdc was cleared.
Note
Before executing the
reservation will be cleared is not being accessed.
If you perform the following operation while both of the following conditions
exist, an error occurs when reservation-key is read, and
is displayed.
Conditions
- Multiple paths are configured to the HDLM device.
504
utility to display the reservation keys for
dlmpr
.
sdf
utility to clear the reservation key.
dlmpr
utility, make sure that the LU for which persistent
dlmpr
,
sda sdb
to clear. Otherwise, enter
y
0x????????????????
, , ,
sdc sdd
.
n