Stopping The Hdlm Manager - Hitachi XP P9500 User Manual

# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver
Alive
KAPL01001-I The HDLM command completed normally. operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
#
When the
Use a script for confirmation:
Execute the following command to confirm that the HDLM manager is active:
# /etc/init.d/DLMManager status
dlmmgr (pid 14889 14886 14884 14880) is running...
Note
If an error occurs, the execution results of the
operation might be different from those of the
In this case, see the execution results of the

4.4.2 Stopping the HDLM Manager

To stop the HDLM manager, log in to Linux as a user with root permissions, and then
execute the following command:
# /etc/init.d/DLMManager stop
Stopping DLMManager:
Lower case characters can be used for the command name (
# /etc/init.d/dlmmanager stop
Stopping DLMManager:
The stop script that was set up during HDLM installation runs, and stops the HDLM
manager.
Use one of the following procedures to confirm that the HDLM manager has stopped:
Use the
dlnkmgr
Execute the following command.
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
HDLM Manager Ver
Dead
KAPL01001-I The HDLM command completed normally. operation
name = view, completion time = yyyy/mm/dd hh:mm:ss
WakeupTime
x.x.x-xx
column shows
HDLM Manager
command's operation:
view
WakeupTime
yyyy/mm/dd hh:mm:ss
, the HDLM manager is active.
Alive
command's
dlnkmgr
DLMManager status
command.
dlnkmgr
[ OK
dlmmanager
[ OK
4. HDLM Operation
view
command.
]
).
]
353