Hitachi XP P9500 User Manual page 445

: Enabled
on
: Disabled
off
Intermittent error monitoring can be set automatic failback is set to
The default is . When you use automatic failback, we recommend that you set
off
intermittent error monitoring to
I/O performance.
If is specified, be sure to also specify the intermittent error monitoring interval
on
and the number of times that the error is to occur. The system assumes that an
intermittent error is occurring if the specified number of times that the error is to
occur is reached during the monitoring interval. A path that is assumed to have an
intermittent error is excluded from automatic failbacks. Intermittent error
monitoring is performed on each path. Intermittent error monitoring starts when
a path is recovered from an error by performing an automatic failback.
If you omit the intermittent error monitoring interval or the number of times that
the error is to occur, each setting is specified as follows:
• When the intermittent error monitoring interval or the number of times that
the error is to occur has not been specified before:
The intermittent error monitoring interval is set to 30 minutes, and the
number of times that the error is to occur is set to 3.
• When the intermittent error monitoring interval or the number of times that
the error is to occur has been specified before:
The values specified from the last time are used.
When a value of 2 or more is specified for the number of times, the following
condition must be satisfied:
error-monitoring-interval
number-of-times-error-is-to-occur-during-intermittent-error-monitoring
If this condition is not satisfied, the KAPL01080-W message will be output and
an error will occur. If this happens, change any of the following settings: the
checking interval for automatic failback, intermittent error monitoring interval, or
the number of times that the error is to occur.
When you set the number of times that the error is to occur to
condition does not need to be satisfied.
The following shows the sub-parameters that should be specified: the error
monitoring interval and the number of times that the error is to occur:
error-monitoring-interval
-intvl
to prevent an intermittent error from reducing
on
checking-interval-for-automatic-failback
>=
6. Command Reference
.
on
x
, the above
1
421