Hitachi XP P9500 User Manual page 223

multipath=off
initrd /initrd-2.6.16.60-0.54.5-smp
multipath=off
3. Check whether the definition in the
Check the contents of the
Figure 3-8: Example Content of /etc/fstab file When using LVM2 shows example
content of
/etc/fstab
Figure 3-8: Example Content of /etc/fstab file When using LVM2
is set in the shaded portion.
LABEL
This example assumes that IA32 uses
that uses as the boot loader, the mount point is displayed as
ELILO
instead of (in the line where
/boot
displayed as
vfat
If is not used in the
LABEL
is used in the
LABEL
file system, and then remove the
4. Execute the
mount
Check the correspondence between the SCSI device and
in steps 3. You will need this information to remove the
Figure 3-9: Example of Executing the mount Command shows an example of
executing the
mount
is set in the underlined section.
/etc/fstab
file.
/etc/fstab
file.
GRUB
/boot
instead of .
ext3
file, go to step 10 and install HDLM. If
/etc/fstab
file, perform steps 4 to 8 to check the mounted
/etc/fstab
setting.
LABEL
command to check the mounted file system.
command.
3. Creating an HDLM Environment
file contains
LABEL
as the boot loader. When you use IPF
is coded), and the file system type is
that you checked
LABEL
setting.
LABEL
.
/boot/efi
199