6.5 online (Places Paths Online)
The
dlnkmgr
paths to be placed online by specifying an HBA port, CHA port, or single path. Instead
of specifying a path, you can also specify a SCSI device name.
6.5.1 Format
(1) To place paths Online
/opt/DynamicLinkManager/bin/dlnkmgr online
[-path]
host-port-number.bus-number
[-hba
|-cha -pathid
|-pathid
|-device
[-s]
(2) To Display the Format of the Online Operation
/opt/DynamicLinkManager/bin/dlnkmgr online -help
6.5.2 Parameters
(1) To place paths Online
-path
Indicates that the target of the operation is a path managed by HDLM.
This parameter is optional because
assumed.
Make sure that you specify the path to be taken online by using the
-pathid
the command will place all the offline paths online. If there is a path that cannot
be placed online, a message asking whether you would like to continue processing
will be displayed. To ignore the offline path that cannot be placed online and to
continue processing, enter
host-port-number.bus-number
-hba
Use this parameter to place online, at one time, all the paths that pass through a
specific HBA port. The command will place online all the paths connected to the
HBA port that has the specified host port number and bus number.
command's
operation places offline paths online. Specify the
online
AutoPATH_ID
AutoPATH_ID
SCSI-device-name
]
, or
parameter. If you do not specify any of these parameters,
-device
. To stop the processing, enter
y
is always used for paths, so it is
online
6. Command Reference
,
,
-hba
-cha
.
n
409