Performing A New Installation Of Hdlm - Hitachi XP P9500 User Manual

3. Creating an HDLM Environment
Figure 3-6: Example of the Contents of the syslogd Settings File (In Red Hat
Enterprise Linux)
When you collect audit log data, we recommend that you use any of the extended
facilities (local0 to local7) as the exclusive output destination for the data. We also
recommend that you specify
example shows how to specify the recommended settings in the
file:
local0.info /usr/local/audlog
(4) Setting the Mount Point (in Red Hat Enterprise Linux 5 or Red Hat Enterprise
Linux 6)
In Red Hat Enterprise Linux 5 or Red Hat Enterprise Linux 6, a DVD-ROM is not
automatically mounted.
Create the
/media/cdrom
(5) Checking the Partition
Confirm that the
directory ( ).
/
Create the
/etc/opt
(6) Xen Settings
If Xen is being used, make sure that domainU has been stopped. If domainU has been
set to automatically start whenever domain0 starts, temporarily change the setting so
that domainU will not start automatically.

3.6.2 Performing a New Installation of HDLM

This subsection describes how to perform a new installation of HDLM. The
preparations before newly installing HDLM are required. For details about the
preparations before installing HDLM, see 3.6.1 Preparations for a New Installation
of HDLM.
To perform a new installation of HDLM:
144
as the severity level for the extended facility. This
info
directory beforehand.
directory is located on the same partition as the root
/etc/opt
directory in advance when configuring the OS.
/etc/syslog.conf