Viewing And Setting Up The Operating Environment; Viewing The Operating Environment - Hitachi XP P9500 User Manual

Initializing Statistical Information for Paths
This section explains how to initialize statistical information (I/O counts and I/
O errors) for all the paths managed by HDLM.
This procedure is useful when you want to check the number of I/O
operations and I/O errors that have occurred since the last time the I/O
counts and I/O errors were initialized to 0.
1 Check the current status of the path.
.
The following is an example of executing the command:
>dlnkmgr -s host-name -u user-name -p password view -path
2 To initialize statistical information for all the paths managed by HDLM,
.
execute the dlnkmgr command's clear operation with the -pdst
parameter specified.
The following is an example of executing the command:
>dlnkmgr -s host-name -u user-name -p password clear -pdst
KAPL01049-I Would you like to execute the operation? Operation
name = clear [y/n]:y
KAPL01001-I The HDLM command completed normally. Operation name
= clear, completion time = yyyy/mm/dd hh:mm:ss
>
3 Check to see whether the statistical information for all the paths has been
.
initialized.
The following is an example of executing the command:
>dlnkmgr -s host-name -u user-name -p password view -path

Viewing and Setting Up the Operating Environment

This section explains how to display and set up the HDLM operating
environment.

Viewing the Operating Environment

To display the operating environment, execute the dlnkmgr command's view
operation with the -sys and -sfunc parameters specified.
The following is an example of executing the command:
>dlnkmgr -s host-name -u user-name -p password view -sys -sfunc
HDLM Version
Service Pack Version
Load Balance
Intermittent Error Monitor
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
>
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for VMware(R))
: x.x.x-xx
:
: on(extended lio)
: off
4-5