Freescale Semiconductor MPC8260 PowerQUICC II Family Reference Manual page 131

Bits Name
18 ILOCK Instruction cache lock
0 Normal operation
1 Instruction cache is locked. A locked cache supplies data normally on a hit, but an access is
To prevent locking during a cache access, an isync must precede the setting of ILOCK.
19 DLOCK Data cache lock
0 Normal operation
1 Data cache is locked. A locked cache supplies data normally on a hit but an access is treated
To prevent locking during a cache access, a sync must precede the setting of DLOCK.
20 ICFI Instruction cache flash invalidate
0 The instruction cache is not invalidated. The bit is cleared when the invalidation operation
1 An invalidate operation is issued that marks the state of each instruction cache block as invalid
21 DCFI Data cache flash invalidate
0 The data cache is not invalidated. The bit is cleared when the invalidation operation begins
1 An invalidate operation is issued that marks the state of each data cache block as invalid
22–23 — Reserved
24 IFEM Enable M bit on 60x bus for instruction fetches
0 M bit not reflected on 60x bus. Instruction fetches are treated as nonglobal on the bus.
1 Instruction fetches reflect the M bit from the WIM settings on the 60x bus.
25–26 — Reserved
27 FBIOB • Force branch indirect on bus.
• 0Register indirect branch targets are fetched normally
• 1Forces register indirect branch targets to be fetched externally.
28 ABE Address broadcast enable
0 dcbf, dcbi, and dcbst instructions are not broadcast on the 60x bus.
1 dcbf, dcbi, and dcbst generate address-only broadcast operations on the 60x bus.
Freescale Semiconductor
Table 2-1. HID0 Field Descriptions (continued)
treated as a cache-inhibited transaction on a miss. On a miss, the transaction to the bus is
single-beat, however, CI still reflects the original state as determined by address translation
independent of cache locked or disabled status.
as a cache-inhibited transaction on a miss. On a miss, the transaction to the bus is single-beat,
however, CI still reflects the original state as determined by address translation independent
of cache locked or disabled status. A snoop hit to a locked L1 data cache performs as if the
cache were not locked. A cache block invalidated by a snoop remains invalid until the cache is
unlocked.
begins (usually the next cycle after the write operation to the register). The instruction cache
must be enabled for the invalidation to occur.
without writing back modified cache blocks to memory. Cache access is blocked during this
time. Bus accesses to the cache are signaled as a miss during invalidate-all operations. Setting
ICFI clears all the valid bits of the blocks and the PLRU bits to point to way L0 of each set. Once
the L1 flash invalidate bits are set through an mtspr instruction, hardware automatically resets
these bits in the next cycle (provided that the corresponding cache enable bits are set in HID0).
2
(usually the next cycle after the write operation to the register). The data cache must be
enabled for the invalidation to occur.
without writing back modified cache blocks to memory. Cache access is blocked during this
time. Bus accesses to the cache are signaled as a miss during invalidate-all operations. Setting
DCFI clears all the valid bits of the blocks and the PLRU bits to point to way L0 of each set.
Once the L1 flash invalidate bits are set through an mtspr instruction, hardware automatically
resets these bits in the next cycle (provided that the corresponding cache enable bits are set
in HID0).
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
Description
2
G2 Core
2-13