Freescale Semiconductor MPC8260 PowerQUICC II Family Reference Manual page 857

Bits Name
0 MODE This mode bit determines whether the HDLC or transparent mode is used. It also determines how
other CHAMR bits are interpreted.
0 Transparent mode. See
Mode."
1 HDLC mode
1 POL Enable polling. POL enables the transmitter to poll the TxBDs.
0 Polling is disabled (The CPM does not access the external bus to check the R bit in the TxBD).
1 Polling is enabled.
POL is used to optimize the use of the external bus. Software should always set POL at the
beginning of a transmit sequence of one or more frames. The CP clears POL when no more buffers
are ready in the transmit queue, i.e. when it finds a BD with R = 0 (for example, at the end of a frame
or at the end of a multi-frame transmission). To minimize useless transactions on the external bus,
software should always prepare the new BD, or multiple BDs, and set BD[R] before enabling polling.
2 1 Must be set.
3 IDLM Idle mode.
0 No idle patterns are sent between frames. After sending NOF+1 flags, the transmitter starts
sending the data of the frame. If the transmission is between frames and the frame buffers are
not ready, the transmitter sends flags until it can start transmitting the data.
1 At least one idle pattern is sent between adjacent frames. The NOF value shall be no smaller than
the PAD setting, see TxBD. If NOF = 0, this is identical to flag sharing in HDLC. Mode flags
precede the actual data. When IDLM = 1, at least one idle pattern is sent between adjacent
frames. If the transmission is between frames and the frame buffer is not ready, the transmitter
sends idle characters. When data is ready, the NOF+1 flags are sent followed by the data frame.
If IDLE mode is selected and NOF = 1, the following sequence is sent:
......init value, FF, FF, flag, flag, data, ........
The init value before the idle will be ones.
4 — This bit must be cleared.
5 RD 0 Normal bit order (transmit/receive the lsb of each octet first)
1 Reversed bit order (transmit/receive the msb of each octet first)
6–7 — These bits must be cleared.
8 CRC Selects the type of CRC when HDLC channel mode is used.
0 16-bit CCITT-CRC
1 32-bit CCITT-CRC
9 — This bit must be cleared.
10 TS Receive time stamp. If this bit is set a 4 byte time stamp is written at the beginning of every data
buffer that the BD points to.If this bit is set the data buffer must start from an address equal to 8*n-4
(n is any integer larger than 0).
Freescale Semiconductor
Table 28-4. CHAMR Field Descriptions
Section 28.3.2.3, "Channel Mode Register (CHAMR)—Transparent
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
Description
Multi-Channel Controllers (MCCs)
28-9