Freescale Semiconductor MPC8260 PowerQUICC II Family Reference Manual page 130

G2 Core
Bits Name
7 PAR Disable precharge of ARTRY.
0 Precharge of ARTRY enabled
1 Alters bus protocol slightly by preventing the processor from driving ARTRY to high (negated)
8 DOZE Doze mode enable. Operates in conjunction with MSR[POW].
0 Doze mode disabled.
1 Doze mode enabled. Doze mode is invoked by setting MSR[POW] after this bit is set. In doze
9 — Reserved, should be cleared.
10 SLEEP Sleep mode enable. Operates in conjunction with MSR[POW].
0 Sleep mode disabled.
1 Sleep mode enabled. Sleep mode is invoked by setting MSR[POW] while this bit is set. When
11 DPM Dynamic power management enable.
0 Dynamic power management is disabled.
1 Functional units enter a low-power mode automatically if the unit is idle. This does not affect
12–14 — Reserved
15 NHR Not hard reset (software-use only)—Helps software distinguish a hard reset from a soft reset.
0 A hard reset occurred if software had previously set this bit.
1 A hard reset has not occurred. If software sets this bit after a hard reset, when a reset occurs
16 ICE Instruction cache enable
0 The instruction cache is neither accessed nor updated. All pages are accessed as if they were
1 The instruction cache is enabled
17 DCE Data cache enable
0 The data cache is neither accessed nor updated. All pages are accessed as if they were
1 The data cache is enabled.
2-12
Table 2-1. HID0 Field Descriptions (continued)
state, allowing multiple ARTRY signals to be tied together. If this is done, the system must
restore the signals to the high state.
mode, the PLL, time base, and snooping remain active.
this occurs, the processor asserts QREQ to indicate that it is ready to enter Sleep mode. The
main PowerQUICC II's PLL remains active and all the internal clocks—including the core's
clock—stop. See Section 10.10, "Basic Power Structure."
operational performance and is transparent to software or any external hardware.
and this bit remains set, software can tell it was a soft reset.
2
marked cache-inhibited (WIM = X1X). Potential cache accesses from the bus (snoop and
cache operations) are ignored. In the disabled state for the L1 caches, the cache tag state bits
are ignored and all accesses are propagated to the bus as single-beat transactions. For those
transactions, however, CI reflects the original state determined by address translation
regardless of cache disabled status. ICE is zero at power-up.
2
marked cache-inhibited (WIM = X1X). Potential cache accesses from the bus (snoop and
cache operations) are ignored. In the disabled state for the L1 caches, the cache tag state bits
are ignored and all accesses are propagated to the bus as single-beat transactions. For those
transactions, however, CI reflects the original state determined by address translation
regardless of cache disabled status. DCE is zero at power-up.
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
Description
1
1
1
Freescale Semiconductor