Enhanced Charging Service Configuration
To configure the IP Readdressing feature, use the following configuration:
configure
active-charging service <ecs_service_name>
charging-action <charging_action_name>
flow action readdress server ipv4_address/ipv6_address [ discard-on-failure ] [
dns-proxy-bypass ] [ port port_number [ discard-on-failure ] [ dns-proxy-bypass ] ]
end
To configure the IP Readdressing feature when the readdress server-list is defined under charging-action, use the
following configuration:
configure
active-charging service service_name
charging-action charging_action_name
flow action readdress server-list server_list_name [ hierarchy ][ round-robin ] [
dns-proxy-bypass ] [ discard-on-failure ]
end
Configuring Next Hop Address
To configure the Next Hop Address configuration feature, use the following configuration:
configure
active-charging service <ecs_service_name>
charging-action <charging_action_name>
nexthop-forwarding-address <ip_address>
end
Configuring Rulebase
A rulebase specifies which protocol analyzers to run and which packets are analyzed. Multiple rulebases may be defined
for the Enhanced Charging Service. A rulebase is basically a subscriber's profile in a charging service.
To create and configure a rulebase, use the following configuration:
configure
active-charging service <ecs_service_name>
rulebase <rulebase_name>
Configuring the Enhanced Charging Service ▀
Cisco ASR 5x00 Enhanced Charging Services Administration Guide ▄
89