Table B-4 Configuration Register Settings For Broadcast Address Destination; Table B-5 System Console Terminal Baud Rate Settings - Cisco EF4116 Hardware Installation And Maintenance Manual

Bit 8 controls the console Break key. Setting bit 8 (the factory default) causes the processor to ignore
the console Break key. Clearing bit 8 causes the processor to interpret Break as a command to force
the system into the bootstrap monitor, halting normal operation. A Break can be sent in the first
60 seconds while the system reboots, regardless of the configuration settings.
Bit 10 controls the host portion of the Internet broadcast address. Setting bit 10 causes the processor
to use all zeros; clearing bit 10 (the factory default) causes the processor to use all ones. Bit 10
interacts with bit 14, which controls the network and subnet portions of the broadcast address.
Table B-4 shows the combined effect of bits 10 and 14.
Table B-4 Configuration Register Settings for Broadcast Address Destination
Bit 14 Bit 10 Address (<net> <host>)
Off Off <ones> <ones>
Off On <zeros> <zeros>
On On <net> <zeros>
On Off <net> <ones>
Bit 13 determines the server response to a bootload failure. Setting bit 13 causes the server to load
operating software from ROM after five unsuccessful attempts to load a boot file from the network.
Clearing bit 13 causes the server to continue indefinitely to attempt loading a boot file from the
network. By factory default, bit 13 is cleared to 0.
Bits 11 and 12 in the configuration register determine the baud rate of the console terminal.
Table B-5 shows the bit settings for the four available baud rates. (The factory-set default baud rate
is 9600.)
Table B-5 System Console Terminal Baud Rate Settings
Baud Bit 12 Bit 11
9600 0 0
4800 0 1
1200 1 0
2400 1 1
Virtual Configuration Register Settings
Cisco 4000 Series Virtual Configuration Register B-5