Installing The Blade Server Cover - IBM BladeCenter JS21 Types 8844 Service Manual

Installing the blade server cover

To install the blade server cover, complete the following steps.
Cover
pins
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed. Do not attempt to override this protection.
1. Lower the cover so that the slots at the rear slide down onto the pins at the rear
2. Pivot the cover to the closed position until it clicks into place.
3. Install the blade server into the BladeCenter unit (see "Installing the blade
146
BladeCenter JS21 Types 7988 and 8844: Problem Determination and Service Guide
Blade-cover
release
of the blade server. Before closing the cover, check that all components are
installed and seated correctly and that you have not left loose tools or parts
inside the blade server.
server in a BladeCenter unit" on page 144).
Blade-cover
release