IBM BladeCenter JS21 Types 8844 Service Manual page 103

SRN Description
A0D-07x Internal service processor firmware error or
incorrect version.
A0D-08x Other internal Service Processor hardware
error.
A0D-09x Service Processor error accessing Vital
Product Data EEPROM.
A0D-18x Service Processor detected NVRAM error.
A0D-19x Service Processor error accessing Real Time
Clock/Time-of-Day Clock.
A0D-21x Service Processor detect error with
Time-of-Day Clock backup battery.
A0D-23x Loss of heart beat from Service Processor.
A0D-24x Service Processor detected a surveillance
time-out.
FRU/action
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
87
Chapter 2. Diagnostics