IBM BladeCenter JS21 Types 8844 Service Manual page 85

SRN FFC
252B-713 252B
252B-714 252B
252B-715 252B
252B-716 252B
293
252B-717 252B
293
252B-718 252B
293
252B-719 252B
252B-720 252B
Description and action
Adapter failure.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Temporary adapter failure.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Temporary adapter failure.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
PCI bus error detected by EEH.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
PCI bus error detected by adapter.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Temporary PCI bus error detected by adapter.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Device bus termination power lost or not detected.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Adapter detected device bus failure.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
69
Chapter 2. Diagnostics