Installing The Blade Server Cover - IBM BladeCenter HS20 Problem Determination And Service Manual

Installing the blade server cover

To install the blade server cover, complete the following steps.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Cover
Pins
Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed. Do not attempt to override this protection.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Lower the cover so that the slots at the rear slide down onto the pins at the rear
3. Pivot the cover to the closed position until it clicks into place.
4. Install the blade server into the BladeCenter unit. See "Installing the blade
60
BladeCenter HS20 Type 7981 and 1884: Problem Determination and Service Guide
Blade-Cover
Release
on page 55.
of the blade server. Before closing the cover, check that all components are
installed and seated correctly and that you have not left loose tools or parts
inside the blade server.
server in a BladeCenter unit" on page 58 for instructions.
Blade-Cover
Release