IBM BladeCenter JS21 Types 8844 Service Manual page 108

SRN Description
A12-13x A non-critical error has been detected, a I/O
host bridge address/data parity error.
A12-15x A non-critical error has been detected, a
system support function error.
A12-16x A non-critical error has been detected, a
system bus internal hardware/switch error.
A12-50x Recoverable errors on resource indicate a
trend toward an unrecoverable error.
However, the resource could not be
deconfigured and is still in use. The system is
operating with the potential for an
unrecoverable error.
A13-00x A non-critical error has been detected, a error
log analysis indicates an error detected by
the I/O device, but the failure could not be
isolated.
A13-01x A non-critical error has been detected, an I/O
bus address parity error.
A13-02x A non-critical error has been detected, an I/O
bus data parity error.
A13-03x A non-critical error has been detected, an I/O
bus time-out, access or other error.
92
BladeCenter JS21 Types 7988 and 8844: Problem Determination and Service Guide
FRU/action
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. If repair is not immediately available, reboot and the
resource will be deconfigured; operations can
continue in a degraded mode.
2. Check the BladeCenter management module event
log for an entry around this time. If no entry is
found, replace the system-board and chassis
assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.