Installing And Closing The Blade Server Cover - IBM Power PS700 Installation And User Manual

3. Turn on the blade server, as described in "Turning on the blade server" on page 13.
Note: If you have just connected the power cords of the BladeCenter unit to electrical outlets, you
must wait until the power-on LED on the blade server flashes slowly before you press the
power-control button.
4. If you installed an I/O expansion card, use the documentation that comes with the expansion card to
install device drivers and to perform any configuration that the expansion card requires.
5. For certain optional devices, run the blade server SMS Utility program, as described in "Using the
SMS utility" on page 39.

Installing and closing the blade server cover

Install and close the cover of the blade server before you insert the blade server into the BladeCenter
unit. Do not attempt to override this important protection.
Figure 16. Installing the cover
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power source. Always replace
the blade server cover before installing the blade server.
Perform the following procedure to replace and close the blade server cover.
Chapter 3. Installing and removing options
33