IBM BladeCenter JS21 Types 8844 Service Manual page 106

SRN Description
A11-510 Resource has been deconfigured and is no
longer in use due to a trend toward an
unrecoverable error.
A11-540 Recoverable errors on resource indicate a
trend toward an unrecoverable error.
However, the resource could not be
deconfigured and is still in use. The system is
operating with the potential for an
unrecoverable error.
A11-550 Recoverable errors on resource indicate a
trend toward an unrecoverable error.
However, the resource could not be
deconfigured and is still in use. The system is
operating with the potential for an
unrecoverable error.
A12-00x A non-critical error has been detected. Error
log analysis indicates an error detected by
the memory controller, but the failure could
not be isolated.
A12-01x A non-critical error has been detected, an
uncorrectable memory error.
A12-02x A non-critical error has been detected, an
ECC correctable error.
A12-03x A non-critical error has been detected, a
correctable error threshold exceeded.
A12-04x A non-critical error has been detected, a
memory control subsystem internal error.
90
BladeCenter JS21 Types 7988 and 8844: Problem Determination and Service Guide
FRU/action
1. Schedule maintenance; the system is operating in a
degraded mode.
2. Check the BladeCenter management module event
log for an entry around this time. If no entry is
found, replace the system-board and chassis
assembly.
1. If repair is not immediately available, reboot and the
resource will be deconfigured; operations can
continue in a degraded mode.
2. Check the BladeCenter management module event
log for an entry around this time. If no entry is
found, replace the system-board and chassis
assembly.
1. If repair is not immediately available, reboot and the
resource will be deconfigured; operations can
continue in a degraded mode.
2. Check the BladeCenter management module event
log for an entry around this time. If no entry is
found, replace the system-board and chassis
assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.