IBM BladeCenter JS21 Types 8844 Service Manual page 45

v If the system hangs on a progress code, follow the suggested actions in the order in which they are listed
in the Action column until the problem is resolved.
v See Chapter 3, "Parts listing, Types 7988 and 8844," on page 137 to determine which components are
CRUs and which components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Progress code
CA00E1D3
CA00E1D4
CA00E1DC
CA00E1DD
CA00E1F0
CA00E1F1
CA00E1F2
CA00E1F3
CA00E1F4
CA00E1F5
CA00E1F6
CA00E1F7
Description
Create SCSI block device node (SD)
Create SCSI byte device node (ST)
Dynamic console selection
A graphics adapter has been selected as
the firmware console, but the USB
keyboard is not attached.
Start out-of-box experience
Start self test sequence on one or more
devices
Power on password prompt
Privileged-access password prompt
End self-test sequence on one or more
boot devices; begin system management
services
Build boot device list
Determine boot device sequence
No boot image located
Action
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Make sure that there is a USB keyboard
attached to a USB port that is assigned to
the partition.
2. Go to "Checkout procedure" on page 106.
3. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
1. Go to "Checkout procedure" on page 106.
2. Replace the system-board and chassis
assembly.
Go to "Boot problem resolution" on page 112.
Chapter 2. Diagnostics
29