Installing The Blade Server Cover - IBM 8038 Installation And User Manual

3. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
4. Turn on the blade server (see "Turning on the blade server" on page 14).If you
5. For certain optional devices, you might have to run the blade server Setup

Installing the blade server cover

Use these instructions for information about how to close the blade server cover.
Attention: You cannot insert the blade server into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
To install the blade server cover, complete the following steps:
1. Read the safety information that begins on page "Safety" on page v and
2. Close the DIMM access door by rotating the door towards the DIMM
3. If you removed an expansion unit from the blade server, install it now (see
4. Lower the cover so that the slots at the rear slide down onto the pins at the
44
BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
server in a BladeCenter unit" on page 45).
have just connected the power cords of the BladeCenter unit to electrical
outlets, you must wait until the power LED on the blade server flashes slowly
before you press the power button.
utility to configure the blade server (see Chapter 4, "Configuring the blade
server," on page 49). See the documentation that comes with your optional
device for additional information.
"Installation guidelines" on page 17.
connectors.
"Installing an optional expansion unit" on page 21).
rear of the blade server, as shown in the illustration. Before you close the cover,
make sure that all components are installed and seated correctly and that you
have not left loose tools or parts inside the blade server.