IBM BladeCenter JS21 Types 8844 Service Manual page 105

SRN Description
A10-210 The processor has been deconfigured. The
system is operating in degraded mode.
A11-00x A non-critical error has been detected. Error
log analysis indicates an error detected by
the CPU, but the failure could not be isolated.
A11-01x A non-critical error has been detected, a CPU
internal error.
A11-02x A non-critical error has been detected, a CPU
internal cache or cache controller error.
A11-03x A non-critical error has been detected, an
external cache parity or multi-bit ECC error.
A11-05x A non-critical error has been detected, a
system bus time-out error.
A11-06x A non-critical error has been detected, a
time-out error waiting for an I/O device.
A11-50x Recoverable errors on resource indicate a
trend toward an unrecoverable error.
However, the resource could not be
deconfigured and is still in use. The system is
operating with the potential for an
unrecoverable error.
FRU/action
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, see "Solving undetermined
problems" on page 135
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
Check the BladeCenter management module event log
for an entry around this time. If no entry is found,
replace the system-board and chassis assembly.
1. If repair is not immediately available, reboot and the
resource will be deconfigured; operations can
continue in a degraded mode.
2. Check the BladeCenter management module event
log for an entry around this time. If no entry is
found, replace the system-board and chassis
assembly.
89
Chapter 2. Diagnostics