IBM BladeCenter JS21 Types 8844 Service Manual page 170

Installing a small-form-factor expansion card
To install a small-form-factor expansion card, complete the following steps.
1. Touch the static-protective package that contains the expansion card to any
2. Orient the expansion card over the system board.
3. Slide the notch in the narrow end of the card into the raised hooks on the
4. Install the blade server cover (see "Installing the blade server cover" on page
5. Install the blade server into the BladeCenter unit (see "Installing the blade
154
BladeCenter JS21 Types 7988 and 8844: Problem Determination and Service Guide
Expansion card
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the expansion card from
its package.
system board; then, gently pivot the card into the expansion card connectors.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
146).
server in a BladeCenter unit" on page 144).