IBM BladeCenter JS21 Types 8844 Service Manual page 96

SRN FFC
25C4-201 25C4
25C4-701 25C4
25C4-601 25C4
25C4-602 25C4
2D02 2631
FFC-724 FFC
FFC-725 FFC
SRNs A00-(x)xxx through A24-(x)xxx
Note: Some SRNs in this chapter may have 4 rather than 3 digits after the dash
(–).
The x in the following SRNs will have a value of 1, 2, 4, or 8, with a meaning as
follows:
SRN Description
A00-FF0 Error log analysis is unable to determine the
error. The error log indicates the following
physical FRU locations as the probable
causes.
A01-00x Error log analysis indicates an error detected
by the CPU, but the failure could not be
isolated.
80
BladeCenter JS21 Types 7988 and 8844: Problem Determination and Service Guide
Description and action
Configuration error. Go to "Performing the checkout procedure" on page 106.
Permanent adapter failure. Go to "Performing the checkout procedure" on page 106.
Download firmware error. Go to "Performing the checkout procedure" on page 106.
EEPROM read error. Go to "Performing the checkout procedure" on page 106.
Generic reference for USB controller/adapter - system-board and chassis assembly
Temporary device bus interface problem.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Temporary device bus interface problem.
1. Check the BladeCenter management module event log. If an error was recorded
by the system or if a checkpoint code is displayed on the console, see "POST
checkpoint codes" on page 9.
2. Replace any parts reported by the diagnostic program.
3. Replace the system-board and chassis assembly.
Number Meaning
1 Replace all FRUs listed
2 Hot swap supported
4 Software might be the cause
8 Reserved
FRU/action
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.